|
|
DESCRIPTION
Replacement 24V DC motor with Hall effect sensor used in our powered declination, azimuth and skew control kits.
NOTE: Requires a controller to count Hall Effect pulses and provide power to the motor. We recommend using a Raspberry Pi as the controller and any 24V DC power supply. You may also use a modified SuperJack/VBox II type positioner to interpret the pulses. However, we do not provide any electronics or programming assistance. Commercial controllers are available but are quite expensive.
NOTE: Wire connections are indicated in the technical specifications below. Do NOT mix up power wires with sensor wires.
FEATURES
- 0.1 degree of precision
- Two quadrature output square pulse sensor signals
INCLUDES
- 24V DC motor with Hall Effect Sensor
- Nuts and bolts
|
Price: $299.00 USD
In-Stock
|
|
TECHNICAL
|
| Specification | Value |
| | |
| Technical | |
| Rated Voltage |
24V DC
| | Rated Current |
< 2.5A
| | Operating Voltage |
5-24V DC
| | Precision |
~0.1 degrees
| | Gear Ratio |
580:1
| | Noise |
< 65 dB
| | IP Class |
IP55
| | Environment |
-40°C to 60°C
|
| Sensor | |
| Output type |
Voltage output (quadrature)
| | Pull up resistor |
Yes
| | Phase Quadrature |
90 degrees
| | Pin 1 (black) |
Motor-
| | Pin 2 (red) |
Motor+
| | Pin 3 (gray) |
Hall-
| | Pin 4 (brown) |
Hall+
| | Pin 5 (blue) |
Hall A
| | Pin 6 (orange) |
Hall B
| | Pin 7 (green) |
GND
|
| Shipping Details | |
| Single Box |
16"x6"x6" Rectangular (14 lbs)
|
|
|
|
hall effect motor, 24vdc motor, tvro slewing drive, hall effect motor, reed switch, limit switch, acme screwjack, 36 Volts, ball screw, motor sensor wires, swivel actuator clamp, hall effect, superjack, venture, moteck, vonweise, jaeger, thomson saginaw
|
|
|
|
)
